Não sei por que haveria dois tanques de expansão instalados, eu investigaria isso ainda mais.
Para responder à sua pergunta, sim, os tanques de expansão podem ficar encharcados. Existem dois tipos principais de tanques de expansão, bexiga e diafragma:
In a bladder tank, there is a rubber bladder that expands and contracts as fluid expands and contracts within the system. In bladder tanks, there is no direct contact between the air in the tank and the fluid in the bladder which will reduce corrosion compared to a atmospheric tank. Bladder tanks can typically fill 100% with fluid, reducing the size of tank needed. The bladder is typically removable and/or replaceable allowing for simpler and less expensive repairs or inspections. Bladder tanks also have an ASME option available. They can also be floor mounted in the vertical position which can save valuable space. Bladder tanks can also be purchased with FDA approved Butyl bladders allowing for use in potable water systems. However, bladder tank usually have a higher initial cost and have a lower maximum allowable temperature than plain steel tanks because of the material of the bladder.
In a diaphragm tank, there is a diaphragm that separates the fluid in the top of the tank and the air in the bottom of the tank. Diaphragm tanks are similar to bladder tanks in that there is no direct contact between the fluid and air in the system, which reduces corrosion. Diaphragm tanks require less maintenance and have a lower installation cost. They can be floor mounted in the vertical position to save space and also come with an ASME option. Unlike bladder tanks, diaphragm tanks have a limited acceptance volume, requiring a larger tank. The diaphragm is not replaceable and the diaphragm tank has a lower maximum temperature than the plain steel tank because of the material of the diaphragm. Source.
Eu acho que os tanques de diafragma são mais comuns agora e eu acho que seu tanque mais novo é desse tipo. Os tanques de diafragma vêm pré-carregados com ar (dependendo de onde estiver instalado, essa pré-carga pode precisar ser ajustada). Com o tempo, o tanque pode perder essa carga de ar e precisa ser recarregado.
Veja algumas informações de about.com sobre esse problema e como corrigi-lo:
Symptoms
- Pressure relief valve on boiler is spurting water
- Expansion tank is hot to the touch lower than the middle of the tank
Possible Causes
- Too little air and too much water in the expansion tank
Possible Repairs
- Turn off boiler, close water shutoff valve and let tank and system cool.
- Water-side pressure must be at 0 psi in order to get an accurate read of the air pressure on the diaphragm.
- Check the pressure in the expansion tank by attaching a tire gage to the air recharge valve (Schrader valve) at the bottom of the tank;
- If air is needed, add more by using a bicycle tire pump to fill the valve to 12 psi or as otherwise indicated by manufacturer's instructions.
- Open water supply valves and let system fill back up.
- Turn boiler back on (do this after water supply is back on)
- System will recharge. Let run for 1-2 hours and recheck.