Que tipo de barreira contra vapor devo instalar ao residir em um prédio antigo com estrutura de madeira?

0

I own a building which was built in the late 1800s. Somewhere in the Forties, the width was doubled. This all on pillars with a crawl space. In the fifties, a large warehouse was attached on a slab and cinder block chain wall. The entire building is in need of re-siding and I intend to use the 5” cement board lap siding to maintain the original look.

My question is about a suitable moisture barrier to use. On the original portion of the building there are vertical 1x12 cypress beneath the existing lap siding. I will not be removing the cypress, which means insulation cannot be added. The rest of the building will have exposed studs once the siding is removed and I can add insulation to those locations. The warehouse is unfinished with exposed rafters and studs inside. The floor and attic has no insulation or barriers.

Should I go with a moisture barrier with the wrinkled surface to allow any moisture an escape route behind the siding, a smooth plastic type barrier or look into one of the thin foil backed foam barriers (not the bubble type)? If I decide to finish the warehouse interior at a later date, should I add a vapor barrier inside at that point? Is it unwise to have vapor barrier in some areas but not others? At the front door recess area is vertical beaded boards. I do not intend to remove those at all.

Thanks for any advice you all may be able to provide.

por Frem 05.04.2019 / 22:07

2 respostas

With the rain and humidity in your area you'll want a breathable house wrap, not plastic or foil, and a drainage plane behind the siding to allow any water that does get through to drain away and dry to the outside.

06.05.2019 / 15:07

I'm not sure what your particular concerns are but I'd do this...

  • Insulate the bare stud area and install modern OSB or plywood sheating. Taper it into the cypress 1x12s with increasing thickness shims over two or three studs.
  • Wrap the entire building with housewrap.
  • Install your siding.

I probably wouldn't install a vapor barrier inside, but you haven't told us where you are, what the climate is or whether you plan to heat the building. If you're in a truly cold climate and will heat you may want to line the interior with poly sheeting before you finish it.

05.04.2019 / 22:21

Tags