Why is my tablesaw whining?

Question

Why is my tablesaw whining?

#1 resposta do (3 votos)

1

I have a Craftsman 113.298031 tablesaw. Recently it has started making a whining sound and the blade is easily bogged down. Previously the blade bogged down without the noise and I had to tighten the belt. This seems different. I took the belt off and the motor seems to run well by itself. I suspect bearings on the blade assembly but haven't taken it apart yet. Any suggestions before I get started? Likely just lube? Might need new bearings? Thanks for anything you can do to shorten the repair process.

manutenção barulho Serra de mesa

por Chris Nelson 22.09.2019 / 18:25

1 resposta

Tags manutenção barulho Serra de mesa

O gás hidrogênio pode ser uma fonte alternativa de combustível para um motor de turbina a gás? Melhor opção para proteger o Lightbox

score 3 · Accepted Answer

My son had a Craftsman 10” saw that the shiv or pulley connection to the shaft was loose. It would spin up but was noisy and when he tried to cut the blade stopped. I checked it out and the set screw had backed off a bit and it did damage the shaft because he had tightened the belt and it worked for a while before he called. I tightened the set screw on the shaft the shaft to pulley or shiv is not perfect because of the spinning damage but with the screw tight it works fine.