Bought a Kingston single hole kitchen faucet. Took out old faucet and installed new one. Hooked up 3/8 to 1/2 braided supply lines. I tested the lines to be sure water came out, which it did, then attached supply lines to faucet.
Everything fits fine but when I opened the water lines again after hooking up the faucet, no water comes out faucet. I did turn the faucet handle 90* to accommodate the beveled breakfast bar. Any ideas?
Is there an aerator in the faucet outlet? If so, remove it, and try turning on again. These often get clogged from debris you shake lose in the lines during installation.
Some faucets also require you to remove part of the valve after installation to flush the lines, then re-install. Check the instructions for your faucet. If you could post the make and model of your faucet, we could look at the instructions and tell you more as well.
Tags torneira